Rolling shop cabinet

Built to house a scrollsaw, this mobile cabinet was designed with comfort and storage in mind

By Art Mulder

No comments

Raised Panels
If you have a panel-raising bit for your router, you can use it in a router table to turn your drawer fronts into raised panels. Raised panels can also be made on the tablesaw with the following simple jig. Cut a piece of plywood four to five inches wide x 14″ to 18″ long. This is the base and will ride along the saw fence. Cut another piece about six inches tall x 12″ to 14″ long. This will be the face to which the drawer front is clamped. Finally, cut two vertical supports about three inches wide x six inches tall, but cut one of the tall sides at an 80º angle. Fasten the vertical supports to the base and the face to the vertical supports. The face board should now lean back at a 10º angle. Leave the tablesaw blade at the standard 90º as the jig features the needed built-in angle.

Clamp the board to be cut to the face of the sled, set the fence width, raise the blade to about 1 1/2″ and make the cut. In order to leave a ridge, which defines the edge of the raised panel, the left side of the blade should just clear the board, while the right side should remain embedded. Test cuts are crucial as you set up for this cut. Hold the sled tight against the fence as you push your stock through the blade.

You may find that the end grain burns a little bit with this jig. This is easily remedied. After making the first cuts on all four sides of the panel, loosen the fence and tap it a smidgen closer to the blade, about 1/32″. Run the end grain parts of the panel through the saw again. Just a tiny amount of wood will be removed, and the burning will be almost totally eliminated-anything left can be sanded out.

Something to Hold Onto
I quite like stainless-steel bar handles as drawer pulls. But because they’re pricey, I designed pulls from shop scraps and a section of maple dowel. They have the look of the large bar handles, but they cost less and suit this project.

Cut two pieces of half-inch dowel to length. Next, cut four end blocks from maple. Carefully set up your drillpress and drill 1/2″-diameter holes using a Forstner bit, about 3/8″ deep into each of the end blocks. Use a fence and stop block on a drillpress table to ensure that all the holes are drilled in the exact same location on each block. Place a few drops of glue in the holes, push the dowels into place and set them aside to dry.

Attach the drawer faces and pulls to the drawer boxes using countersunk screws. You can also position the cabinet top in place now and fasten it down.

On a Roll
The final step in this project’s construction is to mount casters on the bottom of the cabinet. Cut some mounting blocks, roughly five inches square, from scrap walnut. Without the blocks, the weight of the cabinet would be carried completely by the bottom of the cabinet. This would place a strain on the joint between the bottom and the sides. The mounting blocks sit under the sides, and help bear the weight. Choose walnut to balance the project visually-so there is walnut trim both at the top and the bottom. Attach one pad at each corner of the cabinet, set in about a 1/4″ to create a shadow line. Fasten the casters to the blocks.

When finishing the piece, avoid aggressive sanding. The face veneer on modern plywoods is thin. For best results, I usually skip straight to fresh 150-grit sandpaper, followed by 220-grit. Vacuum off the dust and wipe on a coat of boiled linseed oil. Wait five minutes and wipe off any excess. After 12 to 24 hours, apply a second coat of oil.

Once the project is dry, buff it with a soft cloth and apply a coat of paste wax to complete the job.


Jump to a section


No comments

To leave a comment, please log in

Don't have an user account? Register for free

Poll

How do you heat your home?

Loading ... Loading ...

Recommendations